How To Install Verizon Extender

Quick Start Guide

Verizon LTE Network Extender

ane. Verizon LTE Network Extender

Thank yous for purchasing a Network Extender to provide enhanced coverage for your Verizon Wireless mobile devices. Use this quick outset guide (QSG) to help you fix upwards your Network Extender, learn how to connect to information technology, and verify that y'all are under Network Extender coverage.

Get to know your device

Depending on device mode, the LED may either testify white or red.
To provide the device with good GPS signal, place the device nearly a window that's without whatsoever metal shielding. If the LCD Display shows "GPS Insucient Error", open the lesser cover and remove the GPS module stowed in the compartment. Delight see GPS Troubleshooting section in this QSG for more than information.
Printing to toggle display options to show device information.
For avant-garde utilise only. Press the Reset push for ten seconds for manufactory reset.

two. What'south in the box

three. Setting Up Your LTE Network Extender

1. Review these Verizon LTE Network Extender Requirements

Cyberspace Access: High speed wired broadband with minimum download speed of 10 Mbps and upload speed of five Mbps, 20 Mbps downwardly and x Mbps up or higher is recommended. NOTE: Home satellite broadband admission is not supported.
A Router/Modem: The Verizon LTE Network Extender must be connected to an available LAN port on a router or modem with ever-on net admission.
GPS point: The Network Extender requires a continuous GPS indicate from the provided GPS antenna.

two. Position Your Verizon LTE Network Extender Consider these factors when choosing a location for your Verizon LTE Network Extender:

For all-time results, place your Verizon LTE Network Extender nigh a window where a strong GPS signal can be acquired. For better GPS signal strength, please pull out and unwrap the GPS extension cable stored at the back of the Network Extender to position the GPS antenna as close to a window equally possible. See the GPS Troubleshooting section for instructions.
Notation: A GPS signal is necessary for the Verizon LTE Network Extender to work properly and to provide your location if you dial 911 in an emergency.
Place your Verizon LTE Network Extender at least x feet abroad from products that generate electromagnetic radiation (east.g., a microwave oven).
Your Network Extender needs to be plugged into a ability outlet.
The Verizon LTE Network Extender can be placed on a flat surface, such as a table or shelf, or mounted to the wall.
NOTE: Optional wall mount brackets are sold separately on verizonwireless.com.

iii. Connect Your LTE Network Extender

Plug ane finish of the provided Ethernet cable into an available LAN port on your router and the other finish to the LAN port on your LTE Network Extender.
Plug the power supply connector into the 12V DC power port located at the rear of the LTE Network Extender.
Plug the Power Adapter into an available outlet.

4. The LTE Network Extender will plow on automatically

When information technology does, startup and self-configuration will begin. This will typically take 5-60 minutes, depending on GPS signal weather condition. Note: If an error message appears on the LCD display, or if Startup takes longer than an hour, please refer to the Startup Troubleshooting table in this QSG. Afterward successful startup, the indicator volition return to o and the display will prove "Service Active…". Press the brandish push to come across boosted information about your Network Extender.

Making Calls Using Your LTE Network Extender

Once the LTE Network Extender is in service, your phone must be within 50 feet, horizontally, of the unit of measurement.To verify your Verizon Wireless telephone is connected to the LTE Network Extender

Make sure your phone has Avant-garde Calling or Hard disk Voice activated.
Dial #48 from your mobile telephone and heed for the post-obit confirmation: You are under 4G LTE Network Extender coverage…"
Some phones may show a domicile icon. NOTE: The range of the Network Extender is dependent on the force of the existing Verizon Wireless network coverage. The utilize of this unit is recommended for areas where 1 bar or less is observed on your telephone.

4. GPS Troubleshooting

If your display even so shows "GPS Insufficient Error" afterward 1 60 minutes, or yous become a GPS mistake message:

Make sure that your LTE Network Extender is at least 10 feet away from whatever communication devices or appliances that generate electromagnetic radiation (east.g., Wi-Fi routers or microwave ovens).
If you lot accept another LTE Network Extender, make sure their GPS antennas are at least 150mm apart.
Brand sure your LTE Network Extender is close to a window. If necessary, use the internal 23' GPS extension cablevision to position the GPS antenna as close to a window as possible. Follow the steps below to accept the internal GPS module out from the LTE Network Extender:
a. Open the rear embrace, as shown in the pictures below, to betrayal the GPS antenna.
b. Take the internal GPS antenna module out.
c. Unwrap the extension GPS cable and place the antenna close to a window. NOTE: If it has taken more than two hours to acquire a GPS betoken, please check the GPS betoken strength on the Admin website. If the indicate is weak, please come across the user guide for additional troubleshooting steps.

5. Startup Sequence with Troubleshooting Tips

6. Other Messages and Troubleshooting Tips

Miscellaneous

If your display shows an error message:

Visit https://world wide web.verizon.com/support/lte-network-extender/for user guide instructions and device information.
To contact Verizon Client Service, call 800-922-0204.

LTE Network Extender Coverage and Capacity

Once your Network Extender is successfully fix, the coverage and capacity volition be as follows:

Coverage: Approximately vii,500 square feet (nigh a fifty-foot radius).
Capacity: Upwards to fourteen active users + i channel reserved for E911 calls + one channel reserved for redirect.
Coverage radius may vary based on the floor plan and RF absorption of the materials in the building.

Accessing Your LTE Network Extender's Admin Website You can manage your LTE Network Extender's settings from its Admin website:

Open a web browser, using a computer connected to the same network (LAN) equally the LTE Network Extender.
Enter "http://" followed by the LTE Network Extender's IP address (e.chiliad., http://192.168.0.10).
Notation: You lot will find the LTE Network Extender's IP address on the LCD display. Use the Display button to navigate to information technology.
Sign in using the default admin password: "LTEFemto + terminal four digits of the MAC ID (Majuscule)" (e.g., LTEFemtoBA56).

https://www.verizonwireless.com/

Read More Well-nigh This Manual & Download PDF:

verizon LTE Network Extender Quick Get-go Guide – Download [optimized]
verizon LTE Network Extender Quick Start Guide – Download

Ezoic